Service Search Receive/Hold Modes - Uniden BC125AT Owner's Manual

During a Service Search, the upper line displays the current
service name. The lower line displays the search frequency and
the direction indicator (↑or ↓) with the modulation.
Enabled service banks appear on the lowest line. Disabled
service bank numbers are not displayed. The currently searched
bank number flashes. You can turn service banks on/off by using
1-9 or 0; however, one service bank must always be enabled. If
you turn off all service banks, the scanner will display Nothing to
Srch.
If you want to change the search direction or if it is a long
transmission and you want to continue searching, turn the
SCROll CONTROl or press Func then Srch/Svc.

Service Search Receive/Hold Modes

To hold on a frequency, press Hold. To step through the
frequencies, turn SCROll CONTROl while in Hold mode. Press
Hold to resume.
While monitoring a transmission, the upper line displays the
current service bank name and the lower line displays the
channel name (if defined) and current frequency with the
direction indicator (↑or ↓).
The modulation, Priority mode icon (if Priority is enabled), any
CTCSS/DCS received (if enabled), and the Close Call icon (if CC
Pri or CC-DND is enabled) will also appear in the display.
Numbers at the bottom of the display show the enabled service
search banks. The currently searched bank number flashes in
Receive mode.
To store a frequency, press Pgm/E. (see Storing Found Search
Frequencies on page 55.)
49