FUTABA 12Z Series Instruction Manual page 98

GYRO
is used to stabilize the aircraft's attitude. The
mode) can be switched with a switch.
switched.
simultaneously controlled.
setup screen shown below by pushing the enter
button.
[Return Key]
switching
(For more information, see the
description at the back of this
manual.)
data input dial to the left and push the enter button.
(For a description of the switch selection method, see the description at
the end of this manual.)
(Example) Setting 3 axes using a GYA351 and GYA352 (2 axes gyro)
*When separating the conditions, set to [SNGL].
front position.
Since switch E is turned OFF at the center, Rate 2 remains [INH].
98 <Model Menu (Airplane/Glider Functions)>
*Initial setting does not assign a sensitivity channel. Use the
Function menu of the Linkage Menu to assign the sensitivity
beforehand.
Set [Control] and [Trim] other than Function to [NULL].
(Currently selected condition name)
the 3 axes Gyro/Gyro2/Gyro3 can be set.
[Cursor Lever]
[Data Input Dial]
PUSH
[Enter Button]