FUTABA 12Z Series Instruction Manual page 96

AIRBRAKE
This function is used when an air brake is
necessary when landing or diving, etc.
The preset elevators and flaps (camber flap,
brake flap) offset amount can be activated by a
switch.
The offset amount of the aileron, elevator, and
flap servos can be adjusted as needed. Also the
be adjusted. (IN side/OUT side) A delay can be set
for each condition, and a Cut switch which will
turn OFF the delay can be chosen. Trim amounts
set the Auto Mode, which will link Airbrake to a
stick, switch, or dial. A separate stick switch or
dial can also be set as the ON/OFF switch.
setup screen shown below by pushing the enter
button.
[Return Key]
96 <Model Menu (Airplane/Glider Functions)>
Move the cursor to the corresponding setting item and adjust
the rate with the data input dial.
match the aircraft.
Mode setting:
Mode: [Manual]
*The display screen is an example. The actual
screen depends on the model type.
(Currently selected condition name)
[Cursor Lever]
[Data Input Dial]
PUSH
[Enter Button]
a n d e l e v a t o r s
offset rate can be
adjusted.
Move the cursor to
the corresponding
s e t t i n g i t e m a n d
adjust the rate with
the data input dial.