FUTABA 12Z Series Instruction Manual page 94

TRIM MIX 1/2
These functions call the ailerons, elevators, and
The amount of ailerons, elevator, and flaps
a switch.
As an example Trim Mix 1 can be set up for
and a slight amount of up elevator. Trim mix
2 can be used for high speed flying, with both
of down elevator.
The trim functions can be activated during
can be set to provide a smooth transition between
the two. Trim Mix 2 will have priority over Trim
Mix 1.
call the setup screen shown below by pushing the
enter button.
[Return Key]
94 <Model Menu (Airplane/Glider Functions)>
and elevators trim rates can be adjusted.
Move the cursor to the corresponding setting item and adjust
the rate with the data input dial.
Example
*When separating the settings for each condition, touch the
group mode button and set it to [Single].
switch can be linked to a stick, etc.
The offset rate can be varied in the Fine Tuning
selection.
operation can be interrupted and each rudder
quickly returned to its original position by selecting a
cut switch.
*The display screen is an example. The actual
screen depends on the model type.
(Currently selected condition name)
PUSH
a n d e l e v a t o r s
offset rate can be
adjusted.
Move the cursor to
the corresponding
s e t t i n g i t e m a n d
adjust the rate with
the data input dial.
[Cursor Lever]
[Data Input Dial]
[Enter Button]