FUTABA 12Z Series Instruction Manual page 87

RUD to AIL
This function is used when you want to mix
the ailerons with rudder operation. It is used
when rudder is applied during roll maneuvers,
knife edge, etc. of stunt planes. It can be used to
bank scale models, large models, etc. like a full
size plane.
menu and call the setup screen
shown below by pushing the
enter button.
[Return Key]
switching
(For more information, refer to
the description at the back of
this manual.)
*The display screen is
an example. The actual
screen depends on the
model type.
Setting method
the data input dial to the left and push the
(For a description of the switch selection method,
see the description at the back of this manual.
The adjustment rate and adjustment direction
can be set,.
method, see the description at the back of this
manual.)
(Currently selected condition name)
*For a description of the curve setting method, see the
description at the back of this manual.
turn
[Fine tuning VR operation mode]
AIL1
AIL 2
(Main Aileron)
(Main Aileron)
AIL 3
(Chip Aileron) (Chip Aileron)
RUDDER 1
Winglet
( )
at Flying wing
V-TAIL
RUDDER 2
RUDDER RUDDER
PUSH
(For a description of the curve setting method,
see the description at the back of this manual.)
and counterclockwise, the mixing
r a t e i n c r e a s e s a n d d e c r e a s e s ,
respectively.
rate increases.
rate increases.
or right of the neutral position, the
mixing rate increases.
<Model Menu (Airplane/Glider Functions)>
AIL 3
RUDDER 2
Winglet
( )
at Flying wing
[Cursor Lever]
[Data Input Dial]
[Enter Button]
87