FUNCTIONS OF LINKAGE MENU
The Linkage Menu is made up of functions
which perform model addition, model type
selection, frequency setting, end point setting, and
other model basic settings.
[Return Key]
*Condition hold operation is displayed.
Linkage Menu functions table
[SERVO MONITOR]: Displays the servo test and operation position
[MODEL SELECT]: Model addition, call, deletion, copy, model name setting
[MODEL TYPE]: Model type, wing type, switch type, etc. selection
[FREQUENCY]: Frequency selection, modulation mode selection, receiver ID setting
[FUNCTION]: Channel assignment of each function can be changed
[SUB-TRIM]: Adjusts the neutral position of each servo
[SERVO-REVERSE]: Servo direction reversal
[FAIL SAFE]: Fail safe function and battery fail safe function setting
[END POINT(ATV)]: Servo basic rudder adjustment and limit setting
[THROTTLE CUT]: Stops the engine safely and easily (airplane and helicopter only)
[IDLE DOWN]: Lowers the idle speed of the engine (airplane and helicopter only)
[SWASH]: Swash AFR and linkage correction function (helicopter only)
[TIMER]: Timer setting and lap time display
[DIAL MONITOR]: Dial, sliding lever, and digital trim position display
[DATA RESET]: Model memory set data reset (by item)
[COND. HOLD]: Condition hold function
48
<Functions of Linkage Menu>
The functions which can be selected depend on
the model type. A typical menu screen is shown
below.
*The display screen is an example. The screen depends
on the model type.
PUSH
To activate/deactivate Condition Hold:
*See p.68 for condition hold function details.
[Cursor Lever]
[Data Input Dial]
[Enter Button]