FUTABA 12Z Series Instruction Manual page 39

Helicopter basic setting procedure
etc. to match the fuselage used.
1. Model addition and call
Default setting assigns 1 model to the T12Z. To
add new models or to call a model already set, use the
Model Select function of the Linkage Menu.
This is convenient when calling a model after
registering the model names in advance. (The data of
up to 25 models can be saved at the transmitter. Data
can also be saved to the optional CF card.)
The currently called model is displayed at the top
When a new model is added, the Model Type Select
screen and Frequency/Modulation mode/Receiver ID
setup screen automatically appear. Change, or check
that they match the type, frequency, and receiver type
of the model used.
2. Model type and swash type selection
If a different model type is already selected, select
helicopter with the Model Type function of the
Linkage Menu, and then select the swash type matched
to the helicopter.
3. Flight condition addition
The transmitter can install up to eight flight
conditions per model. You can assign all switches
including sticks, switches, trim levers and trim switches
as flight-condition selection switches. You can also
avoid sudden changes. Moreover, you can set priority
condition. In addition, you can copy conditions and/or
change names of conditions. This command may also
be used to define what switches and/or controls are
The Condition Select function automatically
only one active when a new model type is defined.
This condition is always on, and remains on until other
conditions are activated by switches.
The Condition Delay can be programmed for each
channel. The Condition Delay is used to change the
servo throw smoothly when switching conditions.
The priority is throttle hold/idle up 2/idle up 1/
normal. Throttle hold has the highest priority.
Add other conditions, as required.
<Model Basic Setting Procedure> 39