FUTABA 12Z Series Instruction Manual page 16

Adjustment of the stick lever length
sticks in line with your hand size.
Lever Head
A
1. Hold the lever head "B" and turn the lever
head "A" counter-clockwise, the lock will be
released.
2. Turn the lever-head "A" clockwise as you hold
the lever-head "B" after placing it as you like.
Adjustment of stick lever tension
The tension of the self-return type stick lever can
1. Remove the rubber grip on the back of the
transmitter.
(J1)
2. Use the accessory 1.5mm hexagonal wrench
to adjust the spring strength as you prefer by
turning the adjusting screw of the stick you
want to adjust.
*Turning the screw clockwise increases the tension.
3) At the end of adjustment, re-install the
rubber grip.
16 <Before Use>
Lever Head
B
3)
)
Adjustment of Throttle Stick (Ratchet System)
You can also choose either airplane ratchet
system or helicopter-touch.
1. Open the dust protection cap on the back
of the transmitter that is covering the hole for
throttle stick adjustment.
2. Use the attached 1.5mm hexagonal wrench
to turn the adjustment screw and set it as you
prefer. Turning the screw clockwise increases
the tension.
For airplane (Mode1)
For helicopter (Mode2)
*This transmitter has two ratchet plates, one for airplane
and the other one for helicopter. If you tighten both screws,
4)
*If you want to change the setting from airplane to helicopter
(or from helicopter to airplane), turn counterclockwise until
the throttle stick moves freely. Then turn the screw for the
helicopter (or airplane) until you get the tension you like.
Hole for throttle
stick adjustment
For helicopter (Mode1)
For airplane (Mode2)