Snap Roll - FUTABA 12Z Series Instruction Manual

SNAP ROLL

This function selects the switch and rate
adjustment of each rudder, (ailerons, elevators, or
right/down, left/up, left/down)
switch in the state in which the direction switch
was switched to the direction in which you want
roll in each direction can be executed by means
of independent switches.
the switch can be set so that snap roll is not
executed when, for instance, the landing
gear is lowered, even if the switch is turned on
accidentally. The snap roll switch is activated only
the setup screen shown below by pushing the
enter button.
[Return Key]
each rudder
104 <Model Menu (Airplane/Glider Functions)>
(Example) Setting example for F3A
executing snap roll)
*The snap roll up side left and right and down side left and right
direction switches are selected here.
The operation speed of each control
be changed and snap roll executed by
stick while there is switch operation can be
performed.
(Currently selected condition name)
PUSH
switching
(For more information, see the
description at the back of this
manual.)
(For a description of the setting method, see the description at
the back of this manual.)
[Cursor Lever]
[Data Input Dial]
[Enter Button]