FUTABA 12Z Series Instruction Manual page 103

RUD to ELE
This function is used when you want to mix
elevator operation with rudder operation. It is used
to correct undesirable tendencies when rudder is
applied in roll maneuvers, knife edge, etc. of stunt
planes.
menu and call the setup screen
shown below by pushing the
enter button.
[Return Key]
switching
(For more information, refer to
the description at the back of
this manual.)
*The display screen is
an example. The actual
screen depends on the
model type.
Setting method
data input dial to the left and push the enter
(For a description of the switch selection method,
see the description at the back of this manual.)
be set.
method, see the description at the back of this
manual.)
(Currently selected condition name)
*For a description of the curve setting method, see the
description at the back of this manual.
turn the
[Fine tuning VR operation mode]
(Fine tuning)
PUSH
and counterclockwise, the mixing
r a t e i n c r e a s e s a n d d e c r e a s e s ,
respectively.
rate increases.
rate increases.
or right of the neutral position, the
mixing rate increases.
<Model Menu (Airplane/Glider Functions)>
[Cursor Lever]
[Data Input Dial]
[Enter Button]
103