Ups Is In Auto-Bypass Mode; General Alarm Condition - HP J4367A - UPS R3000 XR User Manual

Off Flashin
g red
Flashing Flashin
red g red
Red Off
Flashing Off
red
Off Off
Flashing Off
red
For the location of individual LEDs, see "UPS front panel LED indicators (on page 8)."

UPS is in Auto-Bypass mode

Action:
If power management software is being used, check the log files to obtain specific error information
1.
to help identify the problem.
For more information about the causes of a general fault condition, see the HP Power Manager user
guide available for download from the HP website (http://www.hp.com/go/rackandpower).
Verify that no blockage of airflow to the front bezel and rear panel exists.
2.
If the LED does not turn off, replace the electronics module.
3.
on page 33)

General alarm condition

Action:
If power management software is being used, check the log files to obtain specific error information
1.
to help identify the problem.
For more information about the causes of a general alarm condition, see the HP Power Manager
user guide available for download from the HP website (http://www.hp.com/go/rackandpower).
Check the batteries:
2.
Allow the UPS batteries to charge for 24 hours.
a.
If the Battery Fault LED is red, replace the batteries
b.
page 36).
Reduce the load:
3.
Power down the UPS
a.
Off Off Flashin
g red
Flashin Flashin Flashin
g red g red g red
Off Off Off
Off Off Flashin
g
green
Off Red Off
Off Off Off
("Powering down the
Off On—1 beep
every 5
seconds
Flashing On—
red Continuous
Off
On—
Continuous
Off On—
Continuous
Off
On—1 beep
every 5
seconds
Red On—
Continuous
("Replacing the UPS electronics
("UPS battery replacement
UPS" on page 31).
Yes On battery—Input
voltage is out of range
(on page 43)
No Internal UPS fault
condition (on page
44)
Yes
Self-test failure
("Battery condition"
on page 43)
Yes REPO condition (on
page 44)
Yes
Site wiring condition
(on page 44)
Yes UPS power capacity is
exceeded ("Overload
condition" on page
44)
module"
procedure" on
Troubleshooting 42