Available Voltage Settings; Initiating A Self-Test - HP J4367A - UPS R3000 XR User Manual

NOTE:
has not been pressed, any new selections are not saved.
For the location of buttons, see "UPS front panel controls (on page 7)."
For the location of LEDs, see "UPS front panel LED indicators (on page 8)."

Available voltage settings

NOTE:
UPS model
R3000 NA
R3000j JPN
R3000h NA, R3000h JPN
R3000 INT

Initiating a self-test

To initiate a self-test, press and hold the Test/Alarm Reset button
for three seconds.
Because a portion of the self-test requires battery power, the self-test cannot be initiated if the batteries are
less than 90 percent charged. If the UPS detects a problem, the appropriate LED
indicators" on page 8) illuminates and an audible alarm may sound.
For information on what to do if the self-test detects a problem, see "Troubleshooting (on page 41)."
Configure mode times out after 2 minutes of inactivity. If the Test/Alarm Reset button
An asterisk (*) indicates the default setting.
Available settings utility voltage (VAC)
100
110
120*
127
100*
110
120
127
200/208*
220
230
240
200/208
220
230*
240
Associated LED
front panel LED
indicators" on page 8)
General Alarm
On Battery
Battery Fault
Site Wiring Fault
General Alarm
On Battery
Battery Fault
Site Wiring Fault
General Alarm
On Battery
Battery Fault
Site Wiring Fault
General Alarm
On Battery
Battery Fault
Site Wiring Fault
("UPS front panel controls" on page 7)
("UPS front panel LED
UPS operations 30
("UPS