Sign in today to find solutions:

Don't have an account? Sign up

   
Switching Between Modes
This seat may only be used in booster mode with children who
stand 42 – 65 in. (106.7 – 165.1 cm) in height and weigh more than
40 lbs (18.2 kg). Britax recommends booster mode only after the
child outgrows harness mode.
Harness to Booster Mode
To remove the harness and buckle:
Loosen the harness.
1
a
Press release lever
b
Pull both harness straps forward
Remove the belt shield and
2
unhook the harness straps from
the yoke.
Replace the belt shield (a) then
3
store the yoke in the slot (b).
46
Pull the harness straps out of
4
the slots.
*
DO NOT remove the HUGS™
chest pads or chest clip.
On the bottom of the seat,
5
slide the retainer of one
harness strap up and pull it
away from the child seat shell.
Turn and slide the retainer
6
through the slot to remove.
*
Pull the harness webbing tight
from the other side before
pulling the retainer through.
Repeat steps 5 and 6 for the
remaining harness buckle strap.
Remove the locking screw
7
from the head restraint
adjuster and insert into the
shell to store.
IMPORTANT: Store the screw in
the slot provided in the shell. Store
all parts of the harness in a safe
place. These parts will be needed
to convert the child seat back to
harness mode.
Switching Between Modes
Locking
Screw storage
47
Next page -> <- Previous page

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: