Britax FRONTIER 85 User Manual page 17

Installing the Child Seat: Harness Mode
Locate the LATCH anchors in
1
your vehicle.
* Ensure harness height is
adjusted to fit your child.
Rotate the positioning block to
2
the front and place the child
seat on the vehicle seat.
Verify that the LATCH strap is
3
not twisted and firmly press
the LATCH connectors onto
their adjacent LATCH anchors
to attach.
Push the child seat into the
4
vehicle seat and pull the end
of the LATCH strap through
the belt slot to secure.
* The child seat is secure when it
cannot be moved front-to-back
or side-to-side more than 1 in.
(2.5 cm) at the belt path. If the
child seat is not secure, repeat
the installation procedure or
use a different seating location.
Firmly press the Versa-Tether
5
hook to the vehicle tether
anchor to attach. Remove all
slack from the tether webbing.
Use the elastic strap to contain
6
extra webbing.
30
1
®
OR
OR
Check Versa-Tether
(Top Tether) attachment
2
Check that there is
LESS than 1 in. (2.5 cm)
of movement (front to back
or side to side) at the belt path
connector attachments
Checklist
Check that positioning block is rotated to the front.
9
9 Check all connections and verify that child seat is secure.
* The child seat is secure when it cannot be moved front-to-
back or side-to-side more than 1 in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat the installation procedure
or use a different seating location.
Ensure any excess Versa-Tether
9
band. Always ensure any excess webbing is contained within
your vehicle.
Installing the Child Seat: Harness Mode
®
<1 in.
Check that the
Check LATCH
Positioning Block is
rotated to the front
webbing is stored in elastic
®
Check that Versa-Tether ®
(Top Tether) webbing is
stored in elastic band
31