Figure 2-5. Accessing the Inside of the System
2-6
Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the SAS drives and
backplane have been properly installed and all connections have been made.
1. Accessing the drive bays
All drives can be accessed from the front of the server. For servicing the CD-
ROM, IDE hard drives and fl oppy drives, you will need to remove the top/left
chassis cover. The SAS disk drives can be installed and removed from the front
of the chassis without removing any chassis covers.
2. Installing components into the 5.25" drive bays
To install components into the 5.25" drive bays, you must fi rst remove the top/
left chassis cover as described in the previous section. Refer to Chapter 6 for
details.
3. Installing CD-ROM and fl oppy disk drives
Refer to Chapter 6 if you need to install a CD-ROM and/or fl oppy disk drive to
the system.
(Rack Confi guration shown)
2-9
Chapter 2: Server Installation