Advertisement
GB
3-06-2004
11:27
Dragon HM3
Pagina 4
Cleaning and maintenance
Your oil filled raditor is absolutely free from maintenance, fully relia-
ble and will give many years of trouble free service. Wipe radiator
with soft damp cloth; do not use detergents or abrasives.
If necessary, use a vacuum cleaner to remove any built-up dirt.
Important notes
-
Do not use your radiator close to bath, wash-basin, shower and
swimming pool.
-
Do not use your radiator to dry laundry.
-
Never place the power cable on top of the radiator while it is hot.
-
Only use the radiator in an upright position.
-
The heater must be positioned at least 50 cm from furniture or
other objects.
-
If the power cable has been damaged, it must be replaced by the
manufacturer or the technical service centre or by a qualified per-
son so as to avoid all risks.
-
In order to eliminate the radiator's "new" smell, set it to maximum
power for at least 8 hours when used for the first time. During this
operation, the room in which the radiator is located must be venti-
lated.
-
It is perfectly normal for the radiator to make "creacking" sounds when
used for the first time. (or in the case of unfrequent use).
-
The radiator must not be located immediately below a fixed socket-outlet.
-
The body of this radiator is filled with a precise quantity of special
oil, so that repairs requiring the opening of the oil body must only
be made by the service agent. Any oil leakage must be reported to
the service agent.
-
Do not use this appliance in rooms having a floor area of less than
4m
2
as this can lead to overheating.
-
If the appliance is scrapped, provisions on the disposal of oil must
be respected.
-
The use of an extension lead is not recommended, as overheating of
the extension lead may occur during the operation of the radiator.
-
As with any electrical appliance, whilst the instructions aim to cover
as many eventualities as possible, caution and common sense should
be applied when operating your appliance, particularly in the vicinity
of young children.
The appliance is fitted with a safety device which will switch off it in
case of accidental overheating. To reset, disconnect the plug from the
power for 30 minutes, remove the cause of overheating then plug the
appliance in again.
ATTENTION: in order to avoid any danger caused by an acciden
resetting of the safety system, this appliance must not be powered
through an external timer.
IMPORTANT: Do not cover the radiator during ope-
ration as this could lead to dangerous overheating,
4
tal
- Quick Links:
- Electrical Connection
Hide quick links:
Advertisement
