Before You Add Or Replace Parts; Adding Memory - Dell PP04S Owner's Manual

Before You Add or Replace Parts

CAUTION: Before working inside your computer, read the safety instructions on
page 9.
Ensure that the work surface is flat and clean to prevent scratching the computer
1
cover.
Save and close any open files, exit any open programs, and then shut down the
2
computer (see "Turning Off Your Computer" on page 41).
Disconnect the computer from the electrical outlet.
3
Wait 10 to 20 seconds, and then disconnect any attached devices.
4
Remove any installed PC Cards and the battery.
5
NOTICE: Handle components and cards by their edges, and avoid touching pins and contacts.
Ground yourself by touching a metal connector on the back of the computer. Continue to ground
yourself periodically during this procedure.

Adding Memory

You can increase your computer memory by installing a memory module on the system
board. See "Memory" on page 116 for information on the memory supported by your
computer. Be sure to add only a memory module that is intended for your computer.
CAUTION: Before working inside your computer, read the safety instructions on
page 9.
NOTE: Memory modules purchased from Dell are covered under your computer warranty.
Ensure that the work surface is flat and clean to prevent scratching the
1
computer cover.
Save and close any open files, exit any open programs, and shut down the computer
2
(see "Turning Off Your Computer" on page 41).
If the computer is connected to the media base (docked), undock it. See the
3
documentation that came with your media base for instructions.
Disconnect the computer from the electrical outlet.
4
Wait 10 to 20 seconds, and then disconnect any attached devices.
5
102 Adding and Replacing Pa rts