System Settings; Speed - VDO MS 3200 Owner's Manual

To customise the navigation functions to your own
needs, you can change several settings.
In the main control, select "
:
The "
The following options are available:

Speed

In the " " menu, you can configure the following settings:
Speed correction
The navigation system uses an average cruising speed to calculate the remaining travel
time and the estimated time of arrival. If required, you can adapt this speed to your
actual average speed.
However, we do not recommend you deviate significantly from the standard value
of 100%.
Move the cursor to the value after "
Press OK.
Set the required speed correction using cursor keys 4 or 6.
To save the setting press OK again.
Speed limit
Use this value to specify the vehicle speed at which a speed warning should be output.
Move the cursor to the value after "
Press OK.
Set the required speed using cursor keys 4 or 6.
To save the setting press OK again.
Activating/deactivating speed warning:
Move the cursor to the option after "
Press OK to choose between "
If the speed warning is activated, a warning sound is triggered each time the set
speed limit is exceeded and a warning appears on the screen.
SDVC Mode (Speed dependent volume control)
This is to compensate the surrounding noise by increasing the volume level of
guidance advice depending on the car's speed.
You can select between 5 different SDVC settings (OFF = off; 4 = maximum increase).
Move the cursor to the value after "
Press OK.
Set the desired SDVC mode using the cursor keys 4 or 6.
To save the setting press OK again.
Find a suitable compensation by trying out the different modes.
" menu is displayed.
" and "

SYSTEM SETTINGS

".
".
".
".
".
".
49