Destination Input Via Gps Coordinates - VDO MS 3200 Owner's Manual

DESTINATION INPUT
Special facilities in the vicinity of the current position
You may also set a destination address by selecting a special facility in the vicinity of
the current vehicle location.
Press the INFO key on the remote control,
or:
select "
:
A list of categories of special facilities is shown.
Select the required category.
:
A list of facilities pertaining to the selected
category, located in the vicinity of the current
vehicle location, appears. Additionally, distance
and direction to the facilities are shown.
Proceed as described on the previous page.
Note:
You will always see a list of facilities from "
facility from the selected category directly at the car position.
The facilities list is sorted by distance to the car position, i.e. the facility closest to the
car position will be first in the list.

Destination input via GPS coordinates

If you know the GPS coordinates of a destination, you
may enter them directly.
In the main control, select "
Select "
"
:
The GPS coordinates input menu appears.
Mark the required coordinate using the cursor
keys. Then press OK.
Next, set the required values for degrees, minutes, seconds and north/south or east/
west using the cursor keys. Confirm the destination input with "
:
The navigation system compares the GPS coordinates you entered with the data on
the current map CD and plans the route.
Notes:
If the destination is beyond the digitised roads, the system will guide you along
digitised roads as far as possible. The system will then display the linear direction and
the distance to the destination.
If the GPS coordinates you entered should be outside the limits of the current map CD,
the system will display an error message.
32
" in the destination input menu.
" from the
" menu.
", even if there is no
".
".