Related Manuals for VDO CHD 1002 S
Summary of Contents for VDO CHD 1002 S
- Page 1 CHD 602S CHD 1002S User manual Mode d’emploi Bedienungsanleitung Gebruiksaanwijzing Istruzioni d’uso Instrucciones de manejo Modo de emprego Bruksanvisning Betjeningsvejledning Käyttöohje www.vdodayton.com...
-
Page 2: Table Of Contents
USER INSTRUCTIONS English CONTENTS General Precautions ..................................Installation Preparation ..................................Mounting ................................... Operation ................................... Troubleshooting ................................Specifications ................................... Laser Product Class 1 ..............................INTRODUCTION This CD changer is designed for use only with car radios which have CD changer controls based on the DIGITAL standard. -
Page 3: Installation Preparation
INSTALLATION PREPARATION FIXING MATERIAL SUPPLIED Fig. 2 Only use screws and fixing material supplied! brackets (L) left and (R) right base-plates with screws (M6 x 20) and double-sided self-adhesive tape hexagonal bolts with washer (M5 x 10) hexagonal nuts (M6) tapping screws (5 x 12) F 12 round stickers for dust protection dust protection stickers for setting shock absorber mechanisms (CHD 1002S only) - Page 4 SHOCK ABSORBER ADJUSTMENT The CD changer is pre-set at the factory for horizontal mounting (Fig. 7). If you mount the CD changer horizontally no adjustment is needed. In this case go to the next section “MOUNTING”. If you mount the CD changer vertically, or at a 45° angle, (or if you later change the mounting angle) you must first change the shock absorber setting.
-
Page 5: Mounting
MOUNTING Caution: Take care not to drill into the fuel tank, the exhaust pipe system, the catalytic converter or the cables laying behind or below any drilled holes! • To prevent dust and dirt entering the unit, glue the supplied stickers F over all unused mounting holes of the CD changer (see Figs. - Page 6 MOUNTING CONNECTING THE CABLES (Fig. 20) Only use the cables supplied to connect the CD changer to the car radio! Ensure that the negative car battery terminal is disconnected. Connect the car radio as described in the car radio’s mounting instructions. Connect the blue plug C3 of the extension cable to the rear of the car radio (socket C3’) (fig.
-
Page 7: Operation
OPERATION FILLING THE MAGAZINE Pull the tab on the magazine’s disc tray to remove one of the trays. Place the disc on the tray with its play surface facing up (label surface facing down). • Each tray can accommodate only one disc. •... - Page 8 OPERATION HANDLING DISCS • Do not drop discs. • Keep discs free from dirt and fingerprints. Scratched discs may cause skipping of music parts. • Do not glue paper or labels on discs. • Do not write on discs. • Do not play damaged or deformed discs. •...
-
Page 9: Troubleshooting
TROUBLESHOOTING An error made in operation or in the connections is sometimes mistaken for a failure or breakdown. Perform the checks described in the following table before calling a Service Agency. Symptom Cause Remedy CD-Changer does not react. Improper connection. Check connections. -
Page 10: Specifications
SPECIFICATIONS CHD 602S Power requirement: 14.4 V DC (11 – 16 V) Weight: 2.0 kg Dimensions (W x H x D): 263mm x 65mm x 175 mm CHD 1002S Power requirement: 14.4 V DC (11 – 16 V) Weight: 2.2 kg Dimensions (W x H x D): 263 mm x 83 mm x 179 mm LASER PRODUCT CLASS 1... - Page 11 3139 166 1062.1 04/01 gm...