Parts Overview - Singer JUNIOR MISS 67B Instructions Manual

Table of Contents

Advertisement

1. SPOOL PIN holds the spool of thread.
2. SPOOL PIN THREAD GUIDE guides thread from the spool.
3. TAKE-UP LEVER pulls the thread from the spool to the needle.
4. PRESSER-FOOT LIFTER raises and lowers the presser foot.
5. NEEDLE carries the thread through the fabric when you sew.
6. PRESSER FOOT holds the fabric against the feed.
(Note: Always put fabric under the presser foot when you sew.)
7. FEED moves the fabric as you sew.
8. SLIDE PLATE opens so you can take the bobbin out. Slide it to the left to open.
Slide it to the right to close.
9. NEEDLE PLATE is the working place for your fabric. The numbered guidelines
help you sew straight seams.
10. TENSION DIAL decides how hard the needle should pull the thread.
11. TABLE CLAMP holds the machine tightly to your table.
12. BOBBIN WINDER holds the bobbin when you wind it. Never leave a bobbin on the winder
while you are sewing.
13. FOOT PEDAL starts the machine when you press your foot on it. The machine stops when
you remove your foot from the pedal. The ON-OFF Switch is located underneath the pedal.
(See Number 16).
14. HAND WHEEL moves the take-up lever and needle at the same time. Always follow the arrows
when you turn the hand wheel.
15. HAND CRANK fits into the slot of the hand wheel so that you can work your machine by hand.
You must turn the power switch to OFF before you use the hand crank. Take the hand crank
out of the hand wheel if you run your machine by battery or electric power.
16. ON-OFF SWITCH is found under the foot pedal. It turns the battery or the electric power ON or OFF.
17. BATTERY HOLDER holds the batteries in the bottom of your machine. Open the latch by turning
it with your fingers or a coin. Place four "D" batteries in the holder with the head of each battery
toward the hand wheel. Remove the batteries if you are not going to sew for more than two weeks.
18. BOBBIN is the little spool that you wind with thread.
19. BOBBIN CASE holds the bobbin while you wer.
20. BOBBIN CASE HOLDER holds the bobbin case while you sew. It moves back and forth to
help the needle form each stitch.
21. MACHINE COVER fits over your machine to protect it. Be sure you remove the hand crank
and wrap the cord around the foot pedal before you put on the cover.
Table of Contents
Junior Miss
A Job For Everything
See how fast you can learn what every part does.
67B
6
Previous Page | Next Page

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents