Dell PP14L Owner's Manual page 86

NOTICE:
working inside the computer.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other
than Dell.
NOTE:
If you are installing a hard drive from a source other than Dell, you need to install an operating
system, drivers, and utilities on the new hard drive.
To replace the hard drive:
1 Follow the procedures in "Before You Begin" on page 83.
2 Turn the computer over, and remove the hard drive screws.
NOTICE:
"Protecting Against Electrostatic Discharge" in the Product Information Guide.
3 Slide the hard drive out of the computer.
4 Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE:
damage the connector.
5 Slide the hard drive into the bay until it is fully seated.
6 Replace and tighten the screws.
7 If the new hard drive is not already pre-imaged, install the operating system and drivers for
your computer.
86
Adding and Replacing Parts
To avoid damaging the system board, you must remove the main battery before you begin
screws (2)
When the hard drive is not in the computer, store it in protective antistatic packaging. See
Use firm and even pressure to slide the drive into place. If you use excessive force, you may
hard drive