Chapter 19 Troubleshooting; Using Leds To Diagnose Problems; Table 19-1 Troubleshooting Power Led; Table 19-2 Troubleshooting Lk/Act Led - ZyXEL Communications Dimension ES-2008 User Manual

Ethernet switch
Table of Contents

Advertisement

19.1 Using LEDs to Diagnose Problems

The LEDs are useful aides for finding possible problem causes.
19.1.1 Power LED
The PWR LED on the front panel does not light up.
STEPS
1
Check the connections from your switch to the power source. Make sure you are
using the supplied power cord and proper power supply. Refer to the product
specifications.
2
Make sure the power source is turned on and that the switch is receiving sufficient
power.
3
If these steps fail to correct the problem, contact your local distributor for
assistance.
19.1.2 The LK/ACT LED
The LK/ACT LED does not light up when a device is connected.
STEPS
1
Verify that the attached device(s) is turned on and properly connected to the
switch.
2
Make sure the network adapters are working on the attached devices.
3
Verify that 10/100/1000 M Ethernet cable length does not exceed 100 meters. For
more information on network cables, see the section on network cable types.
19.1.3 The 100 LED
The 100 LED does not show the speed of my Ethernet device.
Troubleshooting

Table 19-1 Troubleshooting Power LED

CORRECTIVE ACTION

Table 19-2 Troubleshooting LK/ACT LED

CORRECTIVE ACTION
Dimension ES-2008 Ethernet Switch
Chapter 19
Troubleshooting
19-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents