Figure 16-13 Smt: Lacp Group Setting; Table 16-2 Smt: Lacp Group Setting - ZyXEL Communications Dimension ES-2008 User Manual

Dimension ES-2008 Ethernet Switch
actions->
Tab=Next Item
Before you configure LACP, you must set the trunk groups first.
The following table describes the fields in this screen.
FIELD
Group
LACP
Work Port No.
Press [ESC] to move the cursor back to the actions menu. Press [TAB] to select <Save>
and press [ENTER] to save the settings back to the switch.
16-8
Dimension Switch ES-2008 : LACP Group Setting
========================
Group
------------------------------------------
Trk1.
Trk2.
<Edit>
Select the action menu.
BackSpace=Previous Item

Figure 16-13 SMT: LACP Group Setting

Refer to the chapter on Port Trunking.

Table 16-2 SMT: LACP Group Setting

This read-only field displays the trunk group number.
Press [SPACE BAR] and [ENTER] to select Enable to activate
dynamic trunking on this trunk group.
Enter the number of ports in the trunk group.
If dynamic trunking is not activated on the trunk group then the
number must be the same as the number of ports in the trunk
group.
If dynamic trunking is activated, you may enter a number bigger
than the number of ports in a trunk group.
LACP Work Port No.
Enabled 2
Disabled 2
<Save>
Quit=Previous menu
DESCRIPTION
Protocol Related Configuration
<Quit>
Enter=Select Item