Assign A Baud Rate; Select The Integrator Mode - Pioneer Kuro KRP-500M Operating Instructions Manual

Flat panel display
Hide thumbs Also See for Kuro KRP-500M:
Table of Contents

Advertisement

Available languages

Available languages

Use Other Equipment With Your Flat Panel Display
06
6.9.2

Assign a Baud Rate

This section describes how to enter the RS-232C transmission speed (baud rate) when controlling or adjusting
the panel using a PC. (Use this option only when making picture adjustments for a specific device(s) connected
to the RS-232C terminal.) The baud rate can be set to 1200bps, 2400bps, 4800bps, 9600bps, 19200bps or
38400bps. To enter a rate, follow the directions below.
1 ) Access
2 ) Select
3 ) Select the desired rate from the submenu.
The factory default setting is 9600bps.
Note: This setting applies to all input sources.

6.10 Select the Integrator Mode

Integrator Mode provides alternative options when using specific functions/settings and picture adjustment
menus.
Notes: Integrator Mode is only available in English.
After entering the Integrator Mode, the following options on the Home Menu are reset to the factory
defaults:
• Picture
• Screen
After entering the Integrator Mode, the following options remain unchanged:
• Sound
• Power Control
• Option
• Input Setup
• Control Setup
To switch to the Integrator Mode, follow the directions below.
1 ) Press INPUT to select the desired input.
2 ) Press DISPLAY to reveal current settings.
Status information on the selected input appears on screen.
74
En
Serial Setting
through the
Baud Rate
from the Serial Setting menu.
Control Setup
menu
.
Baud Rate
1200bps
2400bps
4800bps
9600bps
19200bps
38400bps
INPUT2
Component
- - -
FULL
Standard

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Krp 500m - 50" lcd flat panel display

Table of Contents