Control An Av System - Pioneer Kuro KRP-500M Operating Instructions Manual

Use Other Equipment With Your Flat Panel Display
06
To connect a device for KURO LINK, follow the steps below.
1 ) Turn on the flat panel display and all other equipment.
2 ) Confirm that the panel's Input Setting for KURO LINK Setting options comply with directions in the
device(s)' operating instructions.
3 ) Confirm that the other equipment is set for KURO LINK.
4 ) Check that the audio and video are playing back properly from the equipment connected through the HDMI
terminal(s).
5 ) Turn Off the flat panel display.
6 ) Pause for a few seconds before turning the panel back on.
7 ) Verify that all equipment is functioning properly.
To select the device to control via KURO LINK, follow the steps below.
1 ) Access
2 ) Select
3 ) Select the desired Input (INPUT 5 or INPUT 6).
4 ) Press EXIT to exit the menu.
If operating an HDMI-supported device using an HDMI port other than the terminal selected in Input Setting, the
system malfunctions. When connecting to an HDMI terminal other than that selected in Input Setting, the
equipment settings should block KURO LINK functions. The KURO LINK menu is not selectable when the option
Input Setting under the KURO LINK Setting menu is set to Off.
The control menu changes to suit the type of HDMI-compatible equipment. When adding, changing, or removing
equipment from KURO LINK, refer to the sections below for installation notes and the supported commands.
6.4.1

Control an AV System

When adding an AV System, connect the unit between the panel and any recorders and/or players. To function
properly, your Audio/Video system manages the KURO LINK functions between the panel and any other
connected equipment.
62
En
KURO LINK Setting
through the
Input Setting
from the submenu.
KURO LINK Setting
Input Setting
Power Off Control
Power On Ready
Hold Sound Status
Control Setup
menu.
: INPUT 5
: Off
: Off
: Off
Power On Test
Power Off Test