Specify The Hdmi Input Type; Specify A Digital Hdmi Signal Type - Pioneer Kuro KRP-500M Operating Instructions Manual

Use Other Equipment With Your Flat Panel Display

6.3.2 Specify the HDMI Input Type

To select a signal type, follow the steps below.
1 ) Select the Input for the connected equipment.
Press the
INPUT
Input Setup 2/2
2 ) Access
5(HDMI 1) or
3 ) Select INPUT
Signal Type
4 ) Select
5 ) Select the appropriate option.
Video
PC
6 ) Press EXIT to exit the menu.
In Video mode, the image is over-scanned (enlarged) but the panel automatically switches to PC when receiving
computer signals. In PC mode, the image displays in full size for optimum image quality.

6.3.3 Specify a Digital HDMI Signal Type

For the correct digital video signal type, check the operating manual that came with the other equipment.
To assign the type of digital signal,follow the steps below.
Input Setup 2/2
1 ) Access
5(HDMI 1) or
2 ) Select INPUT
Video
3 ) Select from the submenu.
4 ) Select the type of digital video signal recommended for the attached device.
Auto
1 (YUV422)
2 (YUV444)
3 (RGB16-235)
4 (RGB0-255)
5 ) Press EXIT to close the menu.
If an image fails to appear, specify another digital video signal type. Type parameters other than Auto need to be
checked for natural colorings.
button (remote control or panel) until the correct input is showing (INPUT 5 or INPUT 6).
Input Setup
through the
6(HDMI 2)
INPUT
from the submenu.
Option
use except when a PC is connected (default)
when a PC is connected to HDMI input terminal
Video (over-scan)
Input Setup
through the
6(HDMI 2).
INPUT
Type
automatically identifies input digital signals
Digital Component Video signals (4:2:2) locked
Digital Component Video signals (4:4:4) locked
Digital RGB signals (16 to 235) locked
Digital RGB signals (0 to 255) locked
.
menu
.
Description
PC (under-scan)
.
menu
Description
06
59
En