Scsi Led Connector: J6; Fan Power Connectors: Cpu0_Fan, Cpu1_Fan, Sys_Fan1 - MSI MS-9282 User Manual

SCSI LED Connector: J6

Connect the J6 to the LED connector on the add-on SCSI adaptor and the HDD LED
will blink when add-on SCSI device is active.

Fan Power Connectors: CPU0_FAN, CPU1_FAN, SYS_FAN1

The fan power connectors support system cooling fan with +12V. W hen connecting
the wire to the connectors, always take note that the red wire is the positive and
should be connected to the +12V, the black wire is Ground and should be connected
to GND. If the mainboard has a System Hardware Monitor chipset onboard, you must
use a specially designed fan with speed sensor to take advantage of the CPU fan
control.
CPU1_FAN
Important
Please refer to the recommended CPU fans at AMD
the vendors for proper CPU cooling fan.
Pin Definition
J6
PIN
1
2
1
3
4
GND
+1 2V
SENSOR
CONTROL
CPU0_FAN
Hardware Setup
SIGNAL
+5V
SCSI LED
HDD LED
+5V
CONTROL
SENSOR
+1 2V
GND
SYS_FAN1
®
official website or consult
2-9