Lenovo ThinkCentre M91p 4524 Hardware Maintenance Manual page 72

Diagnostic Error Code
086-199-XXX Mouse Port interface test failed, cause
unknown
089-000-XXX Microprocessor Test Passed
089-XXX-XXX Microprocessor failure
089-195-XXX Microprocessor Test aborted by user
089-196-XXX Microprocessor test halt, error threshold
exceeded
089-197-XXX Microprocessor test warning
089-198-XXX Microprocessor test aborted
089-199-XXX Microprocessor test failed, cause unknown
170-000-XXX Voltage Sensor(s) Test Passed
170-0XX-XXX Voltage Sensor(s) failure
170-195-XXX Voltage Sensor(s) Test aborted by user
170-196-XXX Voltage Sensor(s) test halt, error threshold
exceeded
170-197-XXX Voltage Sensor(s) test warning
170-198-XXX Voltage Sensor(s) test aborted
64
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. See "Undetermined problems" on page 71
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 511
3. Replace component under function test
No action
1. Microprocessor(s)
2. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. Flash the system. See "Updating (flashing) the BIOS
from a disc" on page 511
2. Go to "Undetermined problems" on page 71
1. See "Undetermined problems" on page 71
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 511
3. Replace component under function test
No action
1. Flash system
2. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 43
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 511
3. Go to "Undetermined problems" on page 71