Set Up For Your Card Design - DataCard CP60 Printer Manual

Set up for your card design

The steps to set up for your card design depend on the Data Format you use.
Set up for CP Driver
1 Install the CP Driver. Choose "Direct Network" when installing the printer.
2 Install Info Central.
3 Open Info Central. In the contents list, locate the "Network Installation" topic in the "Installation" book. Scroll
down to the steps for your type of connections—wired or wireless—to complete driver installation.
4 In Info Central, locate the "Setting up for your card design" book. Follow the guidance provided to complete
driver and printer setup.
Set up for the Open Card data format
The Open Card option is required to use the Open Card data format. See
determine whether you have the Open Card option.
1 Prepare the data by using Open Card commands. (At a minimum, use the Start and End Data commands.)
2 Use the Card Layout menus available through the printer Telnet interface to set up a card design.
3 See the Data Formatting Guide for more information.
"Features and options" on page 3
Page 35
to