Configure Wep In Ap Mode - D-Link Xtreme N Duo DAP-1522 User Manual

Section  - Security
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please
establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption
due to the added overhead.
1. Log into the web-based configuration by opening a web browser and entering the IP address of the access point
(192.168.0.50). Click on Setup and then click Wireless Settings on the left side.
2. Next to Security Mode in the Wireless Security Mode
section, select WEP.
3. Next to WEP Key Length in the WEP section, select both the type
of input (hexidecimal or ASCII) and the level of encryption (64-
bit or 128-bit). Hex - (recommended) Letters A-F and numbers 0-9
are valid.
4. Next to Default WEP Key and the first selection on the
drop-down menu, WEP Key 1. Enter a WEP key that you create in the WEP Key value and Verify WEP Key value
fields. Make sure you enter this key exactly on all your wireless devices. You may enter up to 4 different keys using
the Default WEP Key drop-down menu.
5. Next to Authentication, select Open or Shared Key.
6. Click Save Settings at the top of the window to save your settings. If you are configuring the access point with a
wireless adapter, you will lose connectivity until you enable WEP on your adapter and enter the same WEP key as
you did on the access point.
D-Link DAP-15 User Manual

Configure WEP in AP Mode

5