Error Indications On The Front Display - Yamaha RX-V373BL Owner's Manual

Error indications on the front display

Message Cause
The unit cannot access the USB device.
Access error
The unit cannot access the iPod.
Check SP Wires The speaker cables short circuit.
Connect error The unit has detected the iPod, but cannot access it.
Internal Error An internal error has occurred.
There are no playable files in the selected folder.
No content
The remote control IDs of the unit and the remote control are not
RemID Mismatch
identical.
The unit cannot play back the songs stored on the iPod for some
Unable to play
reason.
Unknown iPod The connected iPod is not supported by the unit.
USB Overloaded An overcurrent is flowing through the USB device.
Remedy
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Turn off the iPod and turn it on again.
Twist the bare wires of the cables firmly and connect to the unit and speakers properly.
Turn off the iPod and then turn it on again.
Contact the nearest authorized Yamaha dealer or service center.
Select a folder that contains files supported by the unit.
Change the remote control ID of the unit or the remote control (p.65).
Check the song data. If it cannot be played on the iPod itself, the song data or storage area may be
defective.
Use an iPod supported by the unit (p.44).
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
APPENDIX ➤ Error indications on the front display
72
En