Yamaha RX-V373BL Owner's Manual page 14

1 2 3 4 5 6 7 8 9
Speaker placement
■
Setting the speaker impedance
(U.S.A. and Canada models only)
Under its default settings, the unit is configured for 8-ohm speakers. When connecting
6-ohm speakers, set the speaker impedance to "6 MIN". In this case, you can also
use 4-ohm speakers as the front speakers.
1
Before connecting speakers, connect the power cable to an AC wall
outlet.
2
While holding down STRAIGHT on the front panel, press z (power).
z (power)
STRAIGHT
3
Check that "SP IMP." is displayed on the front display.
SP IMP. 8 MIN
4
Press STRAIGHT to select "6 MIN".
5
Press z (power) to set the unit to standby mode and remove the
power cable from the AC wall outlet.
You are now ready to connect the speakers.
PREPARATIONS ➤ Placing speakers
14
En