Jumpers Setup; Connectors - ASROCK K7VM2 User Manual

2.7 Jumpers Setup

2.7 Jumpers Setup
2.7 Jumpers Setup 2.7 Jumpers Setup 2.7 Jumpers Setup
The illustration shows how jumpers are setup.
When the jumper cap is placed on pins, the jumper
is "SHORT". If no jumper cap is placed on pins,
the jumper is "OPEN". The illustration shows a
3-pin jumper whose pin1 and pin2 are "SHORT"
when jumper cap is placed on these 2 pins.
Jumper
FSB_SEL1
(see p.6 item 28)
Note: Follow the figures to set the CPU front side bus frequency.
PS2_USB_PWR1
(see p.6 item 22)
Note: To select +5VSB, it requires 2 Amp and higher standby current.
CLRCMOS1
(see p.6 item 17)

2.8 Connectors

2.8 Connectors 2.8 Connectors 2.8 Connectors 2.8 Connectors
Connectors are NOT jumpers. DO NOT place jumper caps over
these connectors.
Connector
FDD connector
(33-pin FLOPPY1)
(see p.6 item 10)
Note: Match the red marking on the floppy ribbon cable with Pin1.
Setting
FSB_SEL1
2_3
FSB 100 MHz
2_3
1_2
+5V +5VSB
solder points
Figure
FLOPPY1
Pin1
Description
FSB_SEL1
1_2
FSB 133 MHz
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB wake up events.
Disconnect the power cord,
then short the solder points
to clear CMOS by using
metal material, e.g., a paper
clip.
Description
Red marking
1 1 1 1 1 1
1 1 1 1