Advertisement
Quick Links
Profile Measuring System
Z500
OMRON's original line beam method provides a
complete solution to profile measurement problems.
Conventional non-contact measurement of the profile of an object commonly
uses a displacement sensor to measure the height of the object, by moving the
object or the sensor.
However, this system has several disadvantages, such as lower measurement
accuracy resulting from object or sensor movement as well as high system con-
struction cost.
By utilizing a unique wide beam method and 2-dimensional CCD, OMRON's
Z500 eliminates these problems.
Through its capability of measuring a diversely-shaped objects in a stable man-
ner, the Z500 can meet a variety of application needs.
Principle of line beam method
A wide beam is applied to the object to be measured. A 2-dimensional CCD receives
the reflected light to measure the 2-dimensional profile of the object.
Measurement of connector pin
configuration
Z500
High-Precision Sensor that Measures and
Displays an Object's Profile.
Features
Application
Height measurement for cream-
soldered joint on PCB
Laser
Projector
lens
Rivet height measurement
Detected image
SW-CCD
Receiver lens
Door gap measurement
B-45
Advertisement
Related Manuals for Omron Z500 Series
Summary of Contents for Omron Z500 Series
- Page 1 Z500 can meet a variety of application needs. Principle of line beam method A wide beam is applied to the object to be measured. A 2-dimensional CCD receives the reflected light to measure the 2-dimensional profile of the object.
- Page 2 Shorter measurement time performed automatically. Four types of monitor screens Measurement data can be displayed on 4 types of monitor screens. These screens enable analysis and evaluation of measurement data from various viewpoints. Profile monitor Image monitor Digital monitor Trend monitor...
-
Page 3: System Configuration
Liquid Crystal Monitor F150-M05L —— Sensor Extension Cable Z309-SC1R (See note) Cable length: 1.5 m, 3 m, 6 m, 8 m or 13 m Monitor Cable F150-VM Cable length: 2 m Note: Specify the required cable length when ordering. Z500... - Page 4 Note: 1 . Defined at 1/e (13.5%) of the density at the light center. Light may, however, be present outside this range and if the reflection factor of the light around the workpiece is high compared to the workpiece, measurement may be affected.
- Page 5 In strong magnetic fields, it may not be possible to maintain resolution performance characteristics. 8 . With the Z500-MC10E/MC15E, at an average number of measurements of 64. Measurement data are sent to PC via RS-232C cable for calculation of their average values.
- Page 6 Weight (including packaging) Approx. 1300 g (Unit: Approx. 700 g) 2 manuals, 1 resistor (250 Ω, 1/2 W) Accessories Note: For measurement at an average number of times of 64 with an OMRON K3AS Linear Sensor Controller connected. B-50 Displacement sensors / Width-measuring Sensors...
-
Page 7: Laser Safety
20.4 to 26.4 VDC Current consumption Approx. 700 mA Ambient temperature Operating: 0 to +50 °C, Storage: -25 to +65 °C (with no icing or condensation) Ambient humidity Operating and storage: 35 to 85 %RH (with no condensation) Weight (including packaging) Approx. - Page 8 Four, 4.5-dia. holes (66.5) ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. Cat. No. Q02E-EN-02 In the interest of product improvement, specifications are subject to change without notice.