Scaling Value Teach; Scaling Value Read - Omron CQM1 Operation Manual

Commands and Responses
7-3-6

Scaling Value Teach

Command
Command Code
Parameter
Response
7-3-7

Scaling Value Read

Command
Command Code
Parameter
E001: This error code will be set to the input word if the parameter is not
within the range covered by the Unit.
This command can be used only when the timing hold in operation mode A is
set to normal.
This command is used to execute scaling value teaching. When scaling value
teaching is executed, the present input value can be used as the X1 or X2
scaling value.
Parameters are not used with this command.
If the wrong command code is set to the output word, the following error code
will be set to the input word.
E000: This error code will be set to the input word if a nonexisting command
code is used.
E002: Teaching command execution error
E003: This error code will be set to the input word if the mode designation for
this command is not correct.
This command is used to read a scaling value.
Parameters are not used with this command.
Teaching scaling value
0: X1
1: X2
Scaling value
0: X1
1: X2
2: Y1
3: Y2
Section 7-3
223