Plc Name - Omron CJ2 CPU UNIT SOFTWARE User Manual

4 CPU Unit Initialization
Additional Information
Setting Program Tasks
The initial settings for assigning programs to tasks is set with the following program properties
using the CX-Programmer.

PLC Name

This is a name that the user sets for the CPU Unit. Make the setting by selecting PLC Info
Info from the PLC Menu of the CX-Programmer.
The system will check if the name registered in the PLC matches the PLC name in the project when
the CX-Programmer is online.
PLC Setup
The PLC Setup is used to make changes for using the CPU Unit with non-default specifications. The
following settings are examples of the defaults for the CPU Unit.
Startup mode: RUN mode
RS-232C port: Host link
Fixed servicing time: 10% of cycle time
To use specifications other than these defaults, change the PLC Setup using the CX-Programmer,
and transfer the PLC Setup to the CPU Unit.
⇒ Transferring PLC Setup from the CX-Programmer
Transferring from the CX-Programmer
4-4
CPU Unit
SYSMAC
RUN
CJ2H
ERR/ALM
CPU64-EIP
INH
PROGRAMMABLE PRPHL
CONTROLLER
COMM
BKUP
OPEN
MCPWR
BUSY
PERIFH ERAL
PLC Setup
PORT
PLC Setup
MS
NS
COMM
10 0M
10M
CJ2 CPU Unit Software User's Manual
−
PLC