Omron CJ2 CPU UNIT SOFTWARE User Manual page 326

9 PLC Setup
←ON
A send delay can be set in no-protocol mode. The operation of this delay is shown in the following
diagram.
Send delay
TXD(236)
The following table shows the message formats that can be set for transmissions and receptions in
no-protocol mode.
Start code None
setting
Yes
No. of bytes received
9-24
Serial port communications settings when DIP switch pin 5
is OFF:
Default settings:
Host link mode,
Custom settings:
Delay
Transmission
Time
None
DATA
ST DATA
Data: 1 to 256 bytes
1 start bit, 7 data bits, even parity,
2 stop bits, and a baud rate of 9,600 bps
Set the communications mode (host link, NT Link,
no-protocol*, or peripheral bus) and other settings,
such as the baud rate.
End code setting
Yes
ED
DATA
ST
DATA
ED
CJ2 CPU Unit Software User's Manual
CR+LF
DATA CR+LF
ST
CR+LF
DATA