Technical Data; General Safety Advice For Electrical Power Tools; Workplace Safety; Electrical Safety - Parkside PFSP 100 - MANUEL 4 Manual

1 Measuring cup
1 Operating instructions
* 1 x prefitted

technical data

Q
Rated power: 100 W
Delivery capacity: 320 ml / min (water)
Viscosity capacity: max. 80 DIN-sec
Pressure: max. 140 bar
Paint cup: 750 ml
Protection class: II /
Noise and vibration data:
The sound pressure level (A-weighted) of the device
is typically 93.9 dB (A). Uncertainty K = 3 dB. The
sound level while working can exceed 106.9 dB (A).
Wear ear protection!
Weighted acceleration, typical: 6.5 m / s
WArNING!
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure and can
be used to compare devices.
Different uses of the device give rise to different
vibration levels and in many cases they may exceed
the values given in these instructions. In some cir-
cumstances it is easy to underestimate the vibration
load if the electrical power tool is used regularly.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
Introduction / General safety advice for electrical power tools
2
General safety advice for
electrical power tools
read all the safety advice
WArNING!
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUC-
TIONS IN A SAFE PLACE FOR FUTURE REFER-
ENCE! THE TERM "ELECTRICAL TOOL" USED
IN THE SAFETY ADVICE REFERS TO ELECTRICAL
TOOLS POWERED BY MAINS ELECTRICITY (BY
MEANS OF A MAINS LEAD) AND ELECTRICAL
TOOLS POWERED BY RECHARGEABLE BATTER-
IES (WITHOUT A MAINS LEAD).

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
b) Do not work with the device
in potentially explosive envi-
ronments in which there are
inflammable liquids, gases or dusts.
Electrical power tools create sparks, which can
ignite dusts or fumes.
c) Keep children and other
people away while you are
operating the electrical tool.
Distractions can cause you to lose control of
the device.

2. electrical safety

to avoid danger to life from
electric shock:
a) the mains plug on the device must match
the mains socket. the plug must not
be modified in any way. Do not use
an adapter plug with devices fitted
with a protective earth. Unmodified
plugs and matching sockets reduce the risk of
electric shock.
GB/MT 17