Synchronizing The Bodypack Transmitter With A Receiver; Synchronizing The Bodypack Transmitter With The Receiver - Individual Operation; Multi-Channel Operation - Sennheiser SK 2000 Instruction Manual

Synchronizing the bodypack transmitter with a receiver

Synchronizing the bodypack transmitter
with a receiver
When synchronizing the bodypack transmitter with a receiver, please
observe the following:
Only use a transmitter and a receiver from the same frequency
range (see the type plates on the transmitter and the
receiver).
Make sure that the desired frequencies are listed in the
enclosed frequency information sheet.
Make sure that the desired frequencies are approved and legal
in your country and, if necessary, apply for an operating
license.
Synchronizing the bodypack transmitter with the
receiver – individual operation
Upon delivery, the bodypack transmitter and the receiver are synchro-
nized with each other. If, however, you cannot establish a transmission link
between bodypack transmitter and receiver, you have to synchronize the
channels of the devices.
For information on automatic synchronization of the bodypack trans-
mitter with the receiver (individual operation), refer to the instruction
manual of the receiver. This information is marked with the
Alternatively, you can set the channel on the bodypack transmitter
manually:
Make sure that you set the bodypack transmitter to the same
frequency bank and the same channel as the receiver (see page 21).
If you still cannot establish a transmission link, read the chapter "If a
problem occurs ..." on page 31.
28
icon.