Memory Mode - Yupiteru MVT-7100 Owner’s Guide Owner's Manual

Memory Mode

Memory mode is used to display the contents of memory which consists of the normal 1000 memory
channels and the 1 priority channel. Memory mode can be verified by the appearance of a single frequency,
the channel number in the upper-left corner and 'CH' LCD indicator.
See the VFO Mode section for details on memory channels are programmed.
Entering Memory Mode
To enter Memory mode from VFO or Scan mode
1. Press MR
To enter Memory mode from Search mode
1. Press MR
2. Now in VFO mode
3. Press MR
To enter Memory mode from Search Pass mode
1. Press C/AC
2. Now in VFO mode
3. Press MR
Displaying Memory Channel Data
The 1000 memory channels have been broken down into 10 banks which are labeled from 1-0. Each bank
consists of 100 channels with each starting at an even frequency (0, 100, 200, etc.).
To move around within the memory channels
1. Use the rotary control or arrow keys
2. When the end of memory is reached in either direction, it will simply wrap around to the other end and
continue
To display a specific memory channel
1. Key in the 3-digit channel number (0-999)
2. Press MR
Displaying Priority Channel Data
The Priority channel is simply memory channel 1000.
To display the priority channel
1. Key in 1000
2. Press MR
3. Channel number is displayed as 'P'
NOTE : The memory channels and priority channel have been separated so
that they do not become confused with each other, even though the priority channel is channel 1000.
Copying Memory Channel To VFO
To copy a memory channel frequency and its settings to the VFO
1. Display the memory channel to be copied
2. Press FUNC + M>V
3. A beep is heard and the radio is now in VFO mode
NOTE : The priority channel can not be copied to the VFO.
Erasing Memory Channel Data
Once a memory/priority channel has been programmed to memory, it is easy to erase the channel contents.