Monitor Out Setup; Pc Setup - Zenith P42W34 Installation And Operating Manual

Monitor Out Setup

Monitor Out Setup
The TV has a special signal output capability which allows you
to hook up a second TV or monitor.
Connect the second TV or monitor to the TV' AV OUTPUT. See
the Operating Manual of the second TV or monitor for further
details regarding that device's input settings.
NOTE: • Component, RGB-PC/DTV 480p/720p/1080i input
sources cannot be used for Monitor out.

PC Setup

PC Setup
- This TV provides Plug and Play capability, meaning that the PC adjusts automatically to its settings. The TV sends configuration
information (EDID) to the PC using the Video Electronics Standard Association (VESA) Display Data Channel (DDC) protocol.
How to connect
1. To get the best picture quality, adjust the PC graphics card to a
640x480, 60Hz.
2. Use the TV's RGB INPUT or DVI (Digital Visual Interface) INPUT
port for video connections, depending on your PC connector.
If the graphic card on the PC does not output analog and digital
RGB simultaneously, connect only one of both RGB INPUT or DVI
INPUT to display the PC on the TV.
If the graphic card on the PC does output analog and digital RGB
simultaneously, set the TV to either RGB or DVI; (the other mode
is set to Plug and Play automatically by the TV.)
3. Then, make the corresponding audio connections. If using a
sound card, adjust the PC sound as required.
How to use
1. Turn on the PC and the TV.
2. Turn on the display by pressing the POWER button on the TV's
remote control.
3. Use the INPUT SELECT button on the remote control to select
RGB or DVI.
4. Check the image on your TV. There may be noise associated with
the resolution, vertical pattern, contrast or brightness in PC mode.
If noise is present, change the PC mode to another resolution,
change the refresh rate to another rate or adjust the brightness
and contrast on the menu until the picture is clear. If the refresh
rate of the PC graphic card can not be changed, change the PC
graphic card or consult the manufacturer of the PC graphic card.
NOTES: • Depending on the graphics card, DOS mode may not
work if you use a DVI-I cable.
• Avoid keeping a fixed image on the TV's screen for a long
period of time. The fixed image may become permanently
imprinted on the screen. Use the Orbiter screen saver
when possible.
• The synchronization input form for Horizontal and Vertical
frequencies is separate.
DC IN ANT IN AV(EXPANDED) INPUT AV OUTPUT REMOTE
(DC 12V) CONTROL
+75
R AUDIO L (MONO) VIDEO R AUDIO L VIDEO
DC IN ANT IN
(DC 12V)
+75
( ) ( ) ( ) ( )
R L
RS-232C INPUT
DVI INPUT
EXTERNAL SPEAKER
(CONTROL/SERVICE)
Installation
ANT OUT
S-VIDEO
OUT
EXPANDED OUTPUT ANT IN
(R) AUDIO (L)
IN
AV(EXPANDED) INPUT AV OUTPUT REMOTE
CONTROL EXPANDED OUTPUT
R L (MONO) R L
AUDIO VIDEO AUDIO VIDEO
EXPANDED
RGB INPUT AUDIO INPUT RGB OUTPUT
INPUT
Owner's Manual 15
VIDEO