Yamaha NS-100S Owner's Manual

English
OWNER'S MANUAL
Thank you for selecting this YAMAHA NS-100S speaker system.
Read these precautions carefully before using your speaker.
Any time you note distortion, reduce the volume control on your
amplifier to a lower setting. Never allow your amplifier to be
driven into "clipping". Otherwise the speaker may be damaged.
When using an amplifier with a rated output power higher than
the nominal input power of the speaker, care should be taken
never to exceed the speaker's maximum input.
Do not attempt to clean the speaker with chemical solvents as
this might damage the finish. To clean, wipe with a dry, soft cloth.
The rear center speaker should be placed behind the listening
position, and equidistant from the two surround speakers.
The positioning of the rear center speaker is important, because it
controls the whole sound quality of a multi channel system.
REMOVING THE FRONT COVER
The front cover is fastened to the enclosure at four points, and can
be removed if desired. To remove the cover, hold on to both sides
and slowly pull straight away from the speaker. To reattach, line up
the four pegs on the inside surface of the cover with the four
corresponding holes on the speaker and push gently.
Note
When the cover is removed, take care not to touch the speaker
units with your hands or to exert excessive force with tools.
NS-100S
PRECAUTIONS
To prevent the enclosure from warping or discoloring, do not
place the speaker where it will be exposed to direct sunlight or
excessive humidity.
Do not place the speaker where it is liable to be knocked over or
struck by falling objects. Stable placement will also ensure better
sound performance.
Secure placement or installation is the owner's responsibility.
YAMAHA shall not be liable for any accident caused by improper
placement or installation of the speaker.

PLACING THE SPEAKER

Type .......................... 2-way 2-speaker bass reflex speaker system
Speaker Unit ............................................ 16 cm (6.5") cone woofer
Nominal Impedance ............................................................. 6 ohms
Frequency Response ............................................... 38 Hz – 35 kHz
Nominal Input Power .............................................................. 100 W
Maximum Input Power ........................................................... 300 W
Sensitivity ................................................................ 90 dB/2.83 V/m
Crossover Frequency .............................................................. 3 kHz
Dimensions (W x H x D) ................................... 212 x 416 x 270 mm
Weight ................................................................... 8.6 kg (19.0 lbs.)
Specifications subject to change without notice due to product
improvements.
Care should be taken not to exceed the input power values
noted above.
Speaker System
Main R
Main L
Subwoofer
Center
Surround L

SPECIFICATIONS

GT
Surround R
NS-100S
(Rear center speaker)
(Magnetically-shielded type)
3 cm (1") dome tweeter
(8.3" x 16.4" x 10.6")