Yamaha RX-V650 Owner's Manual page 33

Yamaha rx-v650: owners manual
Hide thumbs Also See for RX-V650:
Table of Contents

Advertisement

Troubleshooting for auto setup procedure
Before auto setup
Error message
Connect MIC!
Unplug HP!
Errors during auto setup
Press SELECT to display detailed information about individual errors. Press j / i to switch between error messages.
Error message
E-1:NO FRONT SP
E-2:NO SURR.SP
E-3:NO PRES. SP
E-4:SBR->SBL
E-5:NOISY
E-6:CHECK SURR.
E-7:NO MIC
E-8:NO SIGNAL
E-9:USER CANCEL
E-10:OTHER ERROR
Warnings after auto setup
Press j / i to display detailed information about individual warnings.
Warning message
W-1:OUT OF PHASE
W-2:OVER 24m
(80ft)
W-3:LEVEL ERROR
• If the ERROR or WARNING screens appears, check the cause of the problem, then perform the auto setup procedure again.
• If warning W-1 appears, corrections are made, but they may not be optimal.
• If warning W-2 or W-3 appears, no corrections are made.
• If error E-10 occurs repeatedly, please contact a qualified YAMAHA service center.
Cause
Optimizer microphone is not connected.
Headphones are connected.
Cause
Front L/R channel signal(s) is (are) not
detected.
A surround channel signal is not detected.
A presence channel signal is not detected.
Only right surround back channel signal is
detected.
Background noise is too loud.
Surround back speaker(s) is (are) connected,
though surround L/R speakers are not.
The optimizer microphone was unplugged
during the auto setup procedure.
The optimizer microphone does not detect test
tones.
The auto setup procedure was cancelled due to
user activity.
A DSP communication error or hangup
occurred.
Cause
Speaker polarity is not correct. This message
may appear depending on the speakers even
when the speakers are connected correctly.
The distance between the speaker and the
listening position is over 24 m (80 ft).
The difference of volume level among speakers
is excessive. (No level correction is made.)
Remedy
• Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
• Unplug the headphones.
Remedy
• Select the front speakers with SPEAKER A or B.
• Check the front left and right speaker connections.
• Check the surround speaker connections.
• Check the presence speaker connections.
• Connect the surround back speaker to the LEFT
SURROUND BACK SPEAKERS terminal if you
only have one surround back speaker.
• Try the auto setup procedure in a quiet environment.
• Turn off noisy electric equipment like air conditioners
(etc.) or move them away from the optimizer
microphone.
• Connect surround speakers when you use (a)
surround back speaker(s).
• Do not touch the optimizer microphone during the
auto setup procedure.
• Check the microphone setting.
• Check the speaker connections and placement.
• Perform the auto setup procedure again. Do not adjust
VOLUME (etc.) during the auto setup procedure.
• Perform the auto setup procedure again.
Remedy
• Check the speaker connections for proper polarity
(+ or –).
• Bring the speaker closer to the listening position.
• Readjust the speaker installation so that all speakers
are set in locations with similar conditions.
• Check the speaker connections.
• Use speakers of similar quality and efficiency.
• Adjust the output volume of the subwoofer.
AUTO SETUP
29

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents