Switches And Dash Mounted Controls; Ignition Switch; Section 1: Controls And Features - Cub Cadet 8404 Operator's Manual

SECTION 1: CONTROLS AND FEATURES

SWITCHES AND DASH MOUNTED CONTROLS

H
C
D
A. Ignition Switch
NOTE: To prevent accidental starting and/or battery
discharge, remove the key from the ignition switch
when the tractor is not in use.
The ignition switch has four positions turning
clockwise as follows (Refer to Figure 2):
OFF - The engine and electrical system is turned off.
ACC - Energizes the accessory circuit.
ON/HEAT - Energizes the tractor's electrical system.
Warning lamps on
momentarily illuminating to test the system. Engine
glowplugs are also energized to preheat the
combustion chamber.
START - Activates the starter motor to turn over and
start the engine. When the engine starts release the
key immediately and it will return to the ON position.
B
A.

Ignition Switch

B. Light Switch
C. Turn Signal Switch
D. Hazard Lamp Switch
E. PTO Switch
the instrument panel
G
Figure 1
F. Steering Tilt Lock Lever
G. Parking Brake Lever
H. Forward/Reverse Shift Lever
I. Hand Throttle Lever
J. Instrument Panel
NOTE: The safety circuit will prevent the starter from
turning if the clutch pedal is not depressed.
On/Heat
are
12
J
F
I
E
A
Start
Off
Figure 2
IGNITION
SWITCH