Problem Solving - Xerox 8830 Operator's Manual

Problem Solving

SYMPTOM
Folder does not switch on.
Folder does not display message "IDLE".
Alarm message
Folding on the leading edge is not parallel.
Incorrect documents face orientation, or folder
showing "NOT FOLDABLE" message.
September 2001
CAUSE
A. Power source is off.
A. The POST (Power On Self-Test) has been
completed with a negative result.
A. Subsystem or sensor failure during the Power
On Self-Test.
A. The print is not cut squarely.
A. Wrong Title Block information
B. Size not deliverable with
orientation.
C. The document is not standard.
D. Size not foldable
A. Ensure that the power cord is connected.
A. Verify jam or alarm status.
A. Follow the alarm and jam clearance
procedure.
A. Follow the
Operator Manual to reload the media.
A. Check the job for a mistake regarding the
Title Block corner indication.
the selected
B. Check the job for:
• Ericsson program that produces an output
always Face Down independently from
the Face selection.
• 198 program that produces an output
always Face Up independently from the
Face selection.
• Or change document orientation.
C. Obtain the original orientation of the
document following the
and then rotate manually the document in the
document rotation option.
D. If all the settings are ok, probably the size
could not be folded due to is dimensions.
88XX Series Folder Operator Manual 46
SOLUTION
instructions in the 8830 Printer
proper procedure