Checking The Original Values Saved In A Program; Restoring The Factory Settings - Vox Valvetronix VT30 User Manual

Checking the original values saved in a program

The original value indication lets you check the parameter values that are saved in a
program.
When you turn a knob to change the value of a parameter, the PRESET LED (if you're
in Preset mode) or the LED of the selected channel (if you're in Channel Select mode)
will momentarily go dark when the edited value matches the value that's stored in
the program.

Restoring the factory settings

Here's how to restore all settings of the VT-series to their factory-set state.
1. Turn off the power.
2. While holding down the [CH1] and [CH4] switches, turn on the power. When the
BANK and CHANNEL LEDs start blinking, release the two switches you had been
holding down.
3. Press the [BYPASS] switch. The BANK and CHANNEL LEDs will change from blink-
ing to lit, and initialization will begin. In one or two seconds, initialization will be
completed, and you will switch to Preset mode.
HINT: When you've found a program that you like, and are interested in know-
ing the actual settings, you can use this original value indication to find out.
NOTE: The top panel [MASTER] volume and rear panel [POWER LEVEL] con-
trols are not programmable, so the original value indication is not available for
these controls. Nor will the original value indication appear when you're in
Manual mode.
NOTE: This operation will erase all programs that had been saved to channels,
and will initialize the factory-set programs.
NOTE: This will also initialize the effect and noise reduction settings that you
made in Manual mode.
HINT: If you decide to cancel initialization at this point, press the [TAP] switch.
NOTE: Never turn off the power while initialization is in progress.
17