Getting Started; Turntable Operation - Crosley Conductor CR73 Instruction Manual

Getting Started

Unpacking
1
Remove packing materials from unit.
Note: Save all packing materials.
2
Remove plastic bag covering radio.
3
Remove plastic safety cover from A/C plug.
4
Remove tie from A/C cord and untie antenna
wire on back of radio.
5
Open lid and remove styrofoam shipping
material from turntable.
6
Remove black tie-wrap from under the tone
arm.
7
Remove white protective needle cover by gently
pulling towards the front of the unit.
8
Untie the FM antenna and allow it to hang down
in a straight line for optimum FM reception. If
you have trouble tuning in an FM station, move
the external FM antenna for best reception. Do
no connect FM antenna to outside antenna.
6
Power Source
1
Unwind the AC POWER CORD (29) at the back
of the unit and connect it to a power outlet.
2
Plug A/C cord into appropriate outlet.
AC
Polarized Plug
Note: This product may be equipped with a
polaized alternating-current line plug (a
plug having one blade wider than the
other.) This plug will fit into the power
outlet only one way. This is a safety
feature. If you are unable to insert the plug
fully into the outlet try reversing the plug,
if the plug should still fail to fit, contact
your electrician to replace your obsolete
outlet. Do not defeat the safety purpose
of the polarized plug.
3
This product is equipped with a polarized
alternating current line plug (a plug having one
blade wider than the other). This plug will fit into
the power outlet only one way. This is a safety
feature, If you are unable to insert the plug fully
into the outlet, try reversing the plug. If the plug
should still fail to fit, contact you electrician to
replace your obsolete outlet. Do not defeat the
purpose of the polarized plug.

Turntable Operation

Press the unit on by switching the ON/OFF-VOLUME
ROTARY KNOB (9) located on the front panel to
the ON position.
1
Select the FUNCTION SWITCH (8) to select
PHONO mode.
2
Set the SPEED CONTROL SWITCH (26) to
desire speed (33 1/3,45 or 78 rpm). Place the
record on the turntable.
3
Pull the TONE ARM (25) slightly to the right
side until hear the "click" sound to activate the
turntable.
4
Move the TONE ARM(25) by hand to the record
and slowly lower it to the desired starting point.
Turn the VOLUME KNOB(9) to adjust the volume
to the desired level.
Turntable Operation
Accessory: ADAPTER FOR 45 RPM
TO PLAY THE 45RPM RECORD, PLACE THE
ADAPTER (24) ON THE SPINDLE (22).
7