Summary of Contents for ViewSonic Office Theater PJ860
Page 1
PJ860 Office Theater User’s Guide Guide de l’utilisateur Bedienungsanleitung Manual de Instrucciones Guida utente Guia do usuário Användarhandbok Руководство для пол зователя Informator użytkownika 31" to 300" (Viewable) Super Bright SVGA LCD Projector Ev-PJ860.p65 01/05/01, 22:12...
Microsoft, Windows, Windows NT, and the Windows Logo are registered trademarks of Microsoft Corporation in the United States and other countries. ViewSonic and the three birds logos, and OnView are registered trademarks of ViewSonic Corporation. Office Theater is a trademark of ViewSonic Corporation.
• • • Clean the air filter after every 100 Contact ViewSonic Customer Service Do not place the projector in an area hours of operation. (See page 16.) for information about where to have containing steam (from a humidifier, the inside cleaned.
Getting Started Congratulations on purchasing a ViewSonic PJ860 Office Theater LCD projector! Save the original box and all packing material for future shipping needs. Package Contents • ViewSonic PJ860 Office Theater • Remote Control Unit/Mouse & Laser Pointer • 2 AA batteries •...
RGB IN S-VIDEO IN VIDEO IN CONTROL RGB OUT AUDIO IN MONO AUDIO IN AUDIO RGB IN S-VIDEO IN VIDEO IN CONTROL RGB OUT AUDIO IN MONO ViewSonic AUDIO IN AUDIO ViewSonic ViewSonic PJ860 Getting Started CRT Display E1-PJ860.p65 01-May-01, 21:16...
2 While pressing the Adjuster Buttons, tilt the front of the projector up in order to adjust the viewing angle. Then (while still grasping the projector) 8 1 Tc1the fro 0 theo 0 Adjusteloksing the frone o le fine adjusemeness, front Adjustess.n Side View Operation ViewSonic PJ860 pr,vmentpoessb,ileinjur ordama,gNr pr rojector 2,...
NOTE: The Magnify function is released when an INPUT SELECT button (on projector or Remote Control Unit) or when the timing mode (resolution or refresh rate) of a personal computer is changed while an image is displayed. Operation ViewSonic PJ860 E2a-PJ860.p65 01-May-01, 21:22...
• May cause parts of the projected image to be slightly dark in some cases • Can not execute when the FREEZE or MAGNIFY function is in use, or when the initial on-screen message is "NO INPUT IS DETECTED" or "SYNC IS OUT OF RANGE." ViewSonic PJ860 Operation E2b-PJ860.p65 01-May-01, 21:24...
(computer) audio source, push one of the Volume buttons. t i s No picture is displayed when either no signal is detected ) l l t c i or when the signal is out of the signal range. Operation ViewSonic PJ860 E2b-PJ860.p65 01-May-01, 21:24...
PJ860. To develop this software you will need various control codes and other supplementary information available from ViewSonic Customer Support. (See page 15.) . f f ViewSonic PJ860 Operation E2b-PJ860.p65...
Brightness may vary with lamp age and environmental conditions. Macintosh computers require a Macintosh adaptor (supplied with the PJ860 projector). All products and trademarks are brand names of their respective companies. Specifications are subject to change without notice. Technical Information ViewSonic PJ860 E3-PJ860.p65 04-May-01, 10:13...
Timing Chart The following table lists the maximum refresh rates that the ViewSonic PJ860 will operate at a number of standard resolutions (timing presets). While the projector is capable of this level of performance, not all video cards are capable of operating at these signal timings. See your graphics card's user guide to ensure compatibility.
Customer Support Most of your questions can be answered as follows: 1 For the nearest ViewSonic authorized service provider, look up the ViewSonic Web site for your region or country. 2 For other assistance contact your reseller, or ask your reseller to refer you to a service center.
Replacing the Lamp Unit ® To order a new lamp unit contact ViewSonic Customer Support. (Part No. RLU-190-03A) 1 Make sure the Main Power switch is OFF, then disconnect the power cord from the wall outlet. If the...
How long the warranty is effective: ViewSonic projectors are warranted for two (2) years for all parts excluding the lamp, two (2) years for all labor, and ninety (90) days for the lamp from the date of the first consumer purchase.