CrimeStopper COOL START RS-900 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. CrimeStopper Manuals
  4. Remote Starter
  5. COOL START RS-900
  6. Operating instructions manual
CrimeStopper COOL START RS-900 Operating Instructions Manual

CrimeStopper COOL START RS-900 Operating Instructions Manual

Vii series
Hide thumbs Also See for COOL START RS-900:

Advertisement

Table of Contents

See also: Instruction and Installation Manual , Operating Instructions Manual
RS-900 / RS-901
SERIES VII
**IMPORTANT NOTES:- FOR RS901 MODEL ONLY**
RS901 Model is an add-on/expansion unit, without remotes or an antenna that must be controlled by an existing
alarm or keyless entry system. The "Infinity Run" feature is not available on an RS-901 system. Most of the
remote start features can be controlled through an existing factory or aftermarket remote keyless entry or alarm
system. Pressing an auxiliary button on an Aftermarket system or pressing a button 3 times on a Factory keyless
remote can activate a remote start using the 901. This is referred to in this manual as activating the "Green Start
input wire".
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY: These are features that must be connected in order for the system to operate properly i.e. Remote
Start connections, Flashing lights, Brake Reset. For programming, the hood pin and program button are required.
-OPTIONAL: These are features are to be connected only if desired or agreed upon by the customer and the
installing dealer i.e. Door Locks, Trunk Pop, Dome Light Illumination, Horn-Honk, Anti-Grind, etc. These features
may also require additional parts and/or labor fees. Consult with your installer beforehand to be sure of what is
going to be installed with your particular system.
TECHNICAL SUPPORT: (800) 998-6880
Monday - Friday 8:00am - 4:30pm Pacific Std. Time
Web Site: www.crimestopper.com
E-mail: email@crimestopper.com
CRIMESTOPPER SECURITY PRODUCTS, INC.
1770 S. TAPO STREET, SIMI VALLEY, CA. 93063
REV A - 07.2004
OPERATING INSTRUCTIONS
This device complies with FCC Rules part 15. Operation is
subject to the following two conditions: 1) This device may not
cause interference, and (2) this device must accept any
interference that may be received, including interference that
may cause undesired operation.
responsible for any radio or TV interference caused by
unauthorized modification to this equipment. Such modification
could void the user's authority to operate the equipment.
The manufacturer is not

Advertisement

Table of Contents
loading

Related Manuals for CrimeStopper COOL START RS-900

Summary of Contents for CrimeStopper COOL START RS-900

  • Page 1 -OPTIONAL: These are features are to be connected only if desired or agreed upon by the customer and the installing dealer i.e. Door Locks, Trunk Pop, Dome Light Illumination, Horn-Honk, Anti-Grind, etc. These features may also require additional parts and/or labor fees. Consult with your installer beforehand to be sure of what is going to be installed with your particular system.

  • Page 2: Table Of Contents

    DO NOT remote start the vehicle in a closed garage. Make sure that the garage door is open or there is adequate ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide...

  • Page 3: Using The Remote Transmitter

    USING THE REMOTE TRANSMITTER The transmitter supplied with the RS-900 system has six buttons. The button configuration of the RS- 900 is Factory-set and unchangeable. The RS901 model does not include remote transmitters, as it is designed for the expansion of a “parent” remote keyless or alarm system.
  • Page 4 3) Engine & parking lights OFF, Doors re-lock/re-arm. ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock system (If equipped) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter &...
  • Page 5 REMOTE ENGINE CONTROL IDLE DOWN MODE - EXITING THE VEHICLE: 1) With vehicle engine running with key, press the Remote Start button for at least one second. (For RS901 model activate Green remote start input wire.) 2) Parking Lights will turn ON. 3) Doors will unlock, or if brake pedal is being depressed, doors will unlock when it is released.
  • Page 6 INFINITY RUN MODE – EXITING THE VEHICLE: 1) With vehicle engine running with the key, press the Remote Start button for at least 1 second, pause a few seconds, then press and release the remote start button a second time. 2) Parking Lights will start flashing, and doors will unlock.

  • Page 7: Turbo Timer Mode

    TURBO TIMER MODE (OPTIONAL) The optional Turbo Timer mode allows the CoolStart system to keep a Turbo or Turbo Diesel vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit the vehicle, and lock the doors remotely. This is handy for turbo cool-down without the need for expensive turbo timers.

  • Page 8: Convenience And Safety Features

    See your installer for programming information on this feature. DOOR LOCK NOTE: If your system has been setup with an optional starter kill relay, but you do not have power door locks, note the following: The lock and unlock buttons on the remote control must still be utilized to operate the Starter disable.

  • Page 9: Convenience And Safety Features

    CONVENIENCE AND SAFETY FEATURES VALET MODE / STARTER DISABLE OVERRIDE Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet mode. The remote start function WILL NOT operate when in Valet mode. To enter Valet mode, turn the key to the ON position, press and hold Program/Valet switch for 5-6 seconds.

  • Page 10: Transmitter Programming

    Note: All transmitter codes must be learned at time of programming!! The RS900 learns up to 4 different transmitter codes. 1. Open Hood (If no hood pin installed with your system, then you must ground the Gray Hood pin wire). 2.

  • Page 11: Vehicle Operation

    A single RS-900VII remote can control two different vehicles with RS-900VII systems installed. SETUP: Follow the “Transmitter Programming” steps on the second vehicle. Program Car #2’s existing remotes, then quickly press the Car #2 side button on your remote before pressing the lock button on your remote to program it to Car #2.
  • Page 12 The RS900 VII system includes a wire that can be used for this Starter #2 circuit. Check with your installer for details. www.crimestopper.com email@crimestopper.com Phone (800) 998-6880 FAX (805) 581-9500 © 2004 Crimestopper Security Products TROUBLESHOOTING cont. ONLINE TECHNICAL SUPPORT www.crimestopper.com/techweb04.html...

This manual is also suitable for:

Cool start rs-901

Table of Contents